Hot Autos, Motorcycles & Planes Posts — Page 25 of 55 « Autos, Motorcycles & Planes

How To: Easily drift in your car

Daydreaming about drifting? Drifting refers to a motorsport where the driver intentionally oversteers, causing loss of traction in the rear wheels through turns, while maintaining vehicle control and a high exit speed. Learn how to drift in your car with help from this video.

News: Just What a Hummer Needs... MORE

You'd think a Hummer couldn't get any more over-the-top (unless you're talking a horse-drawn Hummer or remote-controlled Hummer, of course), but Japanese tuner Calwing’s US division, 213 Motoring has come out with a Hummer boasting a whole extra set of wheels. I'm not quite sure why this is necessary, but nonetheless, Bornrich reports:

How To: Polish aluminum wheels

Are you aluminum wheels dull and unpolished? Make your car shine with help from this video! Polish up those aluminum wheels the right way and get them to sparkle with a little guidance from an expert.

How To: Adjust the disk brakes on a bicycle

For the hardcore bicycle enthusiast, repairing your own bike is a fact of life. It only gets more challenging the more advanced and elaborate your bike is. This video will teach you how to adjust your manually pulled Shimano disk brakes for better performance. And for preventing you from flying into an intersection when your brakes fail.

How To: Remove the crankshaft sensor on a Nissan Sentra

If you own a Nissan Sentra and know anything about working on cars, you've probably realized how blessed you are to own such an easy car to repair yourself. This handy video shows how to perform one piece of maintenance on the car quickly and easily, removing the crankshaft sensor. You'll need to do this if your sensor has corroded as the one in this video has.

How To: Troubleshoot a car that has a high idle

Does your car idle high and make an obnoxious racket every time you are stopped at a light, drawing dispproving looks from your fellow motorists? If you are into home car maintenance, you may be able to diagnose the cause of this problem yourself. This video illustrates how to test for one common problem that leads to a high idle, a faulty throttle position sensor, the contacts on which have been worn down by the throttle. You will need an analog multimeter to test the ohm load from the senso...

How To: Change your radiator fluid

Your radiator fluid is one of the many important aspects of your car. Neglecting your radiator fluid can cause expensive damage to your car and put it in the shop for much longer than you want to deal with! So listen up and find out how to properly change your car's radiator fluid. This video from Watch Mojo will show you how to change your car's radiator fluid.

News: Piss’d Off Pete, the $100K Super Hot-Rod Hauler

After 3,000 man hours and $100 grand spent, 49-year-old Randy Grubb of rural Oregon turned this old junker long-haul truck...

How To: Change front brake pads and rotors

Changing brakes to a car is just as important as it is to changing the oil. Both are required to ensure that you have a safe, working vehicle. Brakes are especially important since no brakes=no stopping. So in this video tutorial, you'll be taken through the process of chaging the front brake pads of your car and the rotors as well. Change front brake pads and rotors.

How To: Make homemade fuse blocks

If you have ever found yourself working on a car project at your home and ran out of fuses, this tutorial is for you. Instead of going out and paying around $30 to $40, make your very own. It's wasy and saves you time and money.

How To: Install a Saturn S-Series radiator deflector & air dam

Richpin gives detailed instructions for attaching the air dam to the radiator deflector for a Saturn S-Series. He also explains how remove the air dam from the car prior to attaching the deflector. Having a properly functioning air dam / deflector assembly is crucial during the summer to keep the engine from overheating.

How To: Remove a bolted hub wheel bearing

In this video Richpin explains how to remove a bolted hub wheel bearing that has gotten frozen onto the car and cannot be removed by conventional means. He explains how to recognize the problem, presents the homemade tool he uses in the repair, briefly explains how to make the tool, and then uses it in conjunction with a sledgehammer to break the bearing off of the car.

How To: Remove the inside rear door panel on a Nissan Altima

In this video richpin explains to us how to remove the inside rear passenger-side door panel on a Nissan Altima. He doesn't explain why you would want to do this, but if you feel compelled to, herein you will find the most detailed instructions you could ask for. Here is a list of the readily available tools that he uses:

How To: Hotwire a Nissan Patrol if you lose your keys

This tutorial is only for those who need it! Please don't be stupid and try to commit a crime. Anyway, in this tutorial you'll find out how to hotwire a Nissan Patrol in the likely event that you lose your keys. Messing with a cars wiring can be bad news if you don't have any idea of what you're doing, so be careful. Good luck and enjoy!

How To: Change the Car Oil on a 2007 Dodge Charger

Need an oil change? Don't mess with taking your car in when you can change your oil right at home! In this video, learn step-by-step how to change the oil on a 2007 Dodge Charger.

How To: Calculate density altitude when you are flying

In flight school, at some point or another you will be asked to determine your density altitude. In this professionally taught tutorial, lean how to calculate density altitude on a flight computer. This lesson is taught by an instructor from the Golden State Flying Club at Gillespie Field in El Cajon, California. So, if you are just beginning to fly, check out this clip and make sure you know all there is to know.

How To: Properly flush your radiator

If your car radiator is not functioning as well as it could, or it is time for some routine maintenance, have a look at this tutorial. Before you go to a pricey mechanic, watch this clip and consider flushing your radiator on your own.

How To: Apply window tints to your car like a professional

If more privacy in your car is what you seek, you may want to consider installing a dark tint to your windows. In this tutorial, Mike Burke of Sunstoppers shows you how car tinting is done right. Mike will show you how to apply a tint just like the professionals do, so that you can get some info on how it's done.

How To: Clean and restore plastic headlights

In order to clean and restore your headlights, you will need the following materials: razor blades, tape, liquid rubbing compound, and a power polisher.

How To: Clean jaundiced plastic headlights

In this how to video, you will learn how to clean your plastic headlights. This is important if you cannot afford to replace the headlights of your classic or semi-classic car. Toothpaste works great as a rubbing compound to fix this. First, take a rag and rub the toothpaste into the headlights. Next, take the paste off with another rag. Use some water to aid you in this. Now, your once clouded lens will be fairly clear. You can then move on to the other side to finish the whole car. This vid...

How To: Remove 3M paint protection film

In this how to video, you will learn how to remove 3M paint protection film, also known as a clear bra. This is used for protecting the front of a vehicle. To remove it, you will need to use a heat gun on the film so that it will peel off. This takes a while to remove, so be patient. The film itself is very useful, as it protects from rock chips and bugs while driving. Note that it is a lot easier to take off during the summer time since the car exterior is already hot. You should not worry a...

How To: Change a flat tire on a moter scooter

In order to change a flat tire on a motor scooter, you will need the following: the wrench that came with your scooter, a tire tube, a socket wrench, an allen wrench, a standard wrench, and a Phillips head screwdriver.

How To: Make a mold for a carbon fiber part

The website carbonmods.com shows up how to make mold for carbon fiber parts. Find a place you would want to put the boards to proceed with the action. Then take the shaping clay and put all around the edges. Cut off all the excess clay to become smooth and lay it out. The next step is waxing. Wax the board about five times, resting five minutes within each wax. apply the blue fluid to clean off buildup. It takes about 20 minutes to dry. To get the surface dry, mix gel and hardener in the same...

How To: Remove window tint

Is the tint on your windows losing its luster? In this video, learn how to remedy a bad window tint. All window film deteriorates with age and eventually have to be removed. Two of the most common symptoms of dying film are the dreaded "purple film" and the "bubbling film". Purple film is caused by non-metallic dyes in the film breaking down and changing color. Bubbling film is a sign that the adhesive used to apply the tint to the window is failing. After a single bubble appears, many more w...

How To: Change your oil for beginners

Changing your oil is an important part of car maintenance. By changing your oil, you can make sure that your vehicle runs smoothly and lasts a long, long time.

How To: Cover parts in carbon fiber by skinning or wrapping

Prepare a chocolate cream roll. And into your whip topping, put in one teaspoon of vanilla extract, about a cap full. Stir the whip, the vanilla removes the packaging taste. Spread the whip all over the cake, nice and thick. Clean out the edges and round it out. With a fork, drag the prongs across the top of the log. And all around the surfaces. With a knife, spiral out the ends of the log. Start in the center and slowly spiral out. Dust the top of the cake with cocoa powder, then do the ends...

How To: Flush your radiator and cooling panel

Learn how to flush your engine coolant and install a radiator cooling panel to help divert more air through your radiator with the help of this automotive maintenance guide. The process, though it might sound difficult, is actually so simple that this video can present a complete overview in just over four minutes' time.

How To: Reset the service engine light on a Saturn S-Series

It is never a good sign when the 'check engine' light comes up on your dashboard. In this tutorial, learn how to reset the light if it is not functioning properly. If you have already fixed the engine issue and wish to reset the warning light on your Saturn S-Series, this video will show you how quick and easy it is to do so.

How To: Make ethanol/alcohol fuel

Gas prices haven't significantly lowered for some time and it looks like they won't either. So some people are trying to find another way to fill up their cars in order to get to work or wherever else they need to go. One way is by making ehtanol fuel or gas. This is a great way to replace gasoline and can be used to power your car and/or a generator. This tutorial will give you the steps needed to make some. Enjoy! Make ethanol/alcohol fuel.

How To: Remove yellow haze from headlights with toothpaste

First of all check for the yellow haze on the headlights by scratching it. Now take toothpaste and then apply some of it on to the headlight. Now you need a dry towel to clean the headlight. Start by rubbing the toothpaste over the headlight with this towel. You have to rub it hard so that the toothpaste cleans out the yellow haze. Start from the middle and make circular motions with the towel. Then start to spread out towards the corners of the headlight. Keep on doing it and you may even fe...

How To: Build a go-kart

As kids, we couldn't wait to drive drive a car and the best way the ahcieve that was by driving a go-kart. Although it's not exactly a car, go-karts are one of the closest things to cars that kids have to drive. It all all the basic fundamentals of a car: steering, the gas nd brake pedal, being able to hurt others with this mechanical beast. It was the best option for kids. In this tutorial, you'll find out how to build a go-kart. Enjoy!

How To: Bleed your car's cooling system (and get the air out)

The temperature control onto hot and the fan is turned off. A bleeder is loosened with a 12mm screwing object. A funnel attachment is placed onto the cooling system and the actual funnel placed ontop. A pre-mixed liquid is poured into the funnel. The bleeder valve is then tightened. Another set of liquid is poured into the funnel and some is poured into a reservoir at about 3/4. The vehicle is started and druiven a few steps back and left on, to run at about 2500 rpm until the cooling fan com...

How To: Remove rust with electricity

This video demonstrates a great way to take rust off of metal piece that are hard to clean by hand. You will need a plastic bucket, a wire hanger, and a battery charger. In the bucket mix one gallon of water and one tablespoon of washing soda. You can make washing soda in the oven by cooking baking soda at 450 degrees for one hour. Take apart all the moving objects off the metal piece you want to clean. Prep the surface by spraying some brake fluid on it and wipe it down. In the bucket hang a...

How To: Replace the radiator to a 2002 Dodge Neon

Although cars are these thousand pound machines that can make travel so much easier for everyone, accidents can occur. So it's important to know what's wrong with your car and how to fix it. If you have a bad or damaged radiator, that is something you need to fix and soon. So, in this video tutorial you'll find out how to replace the radiator to a 2002 Dodge Neon. Enjoy and good luck!

How To: Change the fluid on a Tremec T45 transmission

Changing the transmission fluid to your car is an important task that every car owner should know how to do. The transmission helps make sure that your car runs smoothly for a long time. So if you want to know how to change the tramsmission fluid to a Tremec T45 transmission, check out the tutorial above to do so. Enjoy!

How To: Restore a headlight

Wipe headlights clean. Double tape around the headlights. Use two layers of tape around the headlight lens to protect the paint. Insert the backing plate into the drill. Attach the foam interface pad. Use a spray bottle of water to lubricate and keep headlights clean while sanding. Completely remove the old UV coating. You'll see heavy sanding marks in the headlight lens. With the 500 grit sandpaper, remove oxidation and pitting. Use uniform movements of up and down and side to side with mode...

How To: Check the fluids in your car

What runs underneath the hood of your car is pretty important. No, scratch that. IT IS VERY IMPORTANT. That is the life force of your vehicle and if you want to make sure you are able to make that car last and use up every penny you have spent on that beautiful piece of machinery, then you better make sure that you constantly check the fluids throughout your car frequently. Oil, transmission, clutch, brake, etc. those fluids help make sure your car will run nice and smoothly for years to come...