Autos, Motorcycles & Planes: Page 34

In this AeroCast episode, UND Aerospace discusses the Slow Flight maneuver as performed in the Piper Warrior (PA-28-161), referencing the procedures and standards outlined in the UND Warrior Standardization Manual. All performance tolerances are based on the performance standards set forth by the FAA Private Pilot Practical Test Standards. Since the most critical phases of flight occur at airspeeds less than cruise, a pilot must always be comfortable with his or her airplane's handling...

In this AeroCast episode, Anthony Bottini discusses the Power On Stall maneuver as performed in the Piper Warrior (PA-28-161), referencing the procedures and standards outlined in the UND Aerospace Warrior Standardization Manual. All performance tolerances are based on the performance standards set forth by the FAA Private Pilot Practical Test Standards. Power On Stall practice is vital in increasing a pilot's proficiency in regards to stall recognition and stall recovery techniques during an...

UND Flight Instructor Anthony Bottini discussing in detail the UND Aerodynamics Demonstration. This maneuver is a must-watch for beginning pilots and old, grizzled aviators. The Aerodynamics Demonstration covers the full spectrum of the Fundamentals of Flight and various other flight principles that a pilot must master before being truly proficient in any aircraft.

Unless you have your own private airport (I'm looking in your direction John Travolta) then you will most likely have to coordinate your takeoffs and landings with all the other air traffic using your specific airport. Whether it be a towered or non-towered airport, this latest UND Video Standardization Lesson is designed to help you, the student pilot, become familiar and hopefully more comfortable with Airport Traffic Pattern operations.

Kevin Tetz of Paintucation give tips for saving your shoulders from a world of hurt by hammering from the wrist when banging out dents and surfaces.

Kevin Tetz of Paintucation gives tips for masking your car before painting it. This is a crucial step to make sure paint and overspray does not get on the wrong spots.

Kevin Tetz of Paintucation shows how to percolate a paint gun to properly clean it.

The rear window is by far the hardest to tint due to the curvature from side to side and usually top to bottom as well. But don't worry, this video will walk you through the tricks to getting that film to lay flat. NOTE: this strip method is older and will work but is rarely used today - there is a one piece shrink fit method used instead.

This episode shows you how to restore the original 'blackness' of your car giving astounding results by rejuvinating rubbers, wipers, doors, tires and handles. Make your car look 200% better in minutes.

The Mighty Car Mods teach you how to install a front mount intercooler kit. The hardest part is usually custom cutting your bumper.

In this episode the boys from Mighty Car Mods show you how to install a turbo boost gauge.

Changing your suspension, ride height or tire size can cause problems with fenders and fender walls rubbing on your tires. This is dangerous and annoying. Watch this video to learn how to roll your fenders (guard rolling) so your tires don't rub.

A killswitch is exactly what you think it is: A switch that kills an operation in an emergency situation when the operation can't be shut down in the usual manner. It shuts your operation no matter what the consequences.

In this episode the team from Mighty Car Mods show you just how easy it is to turn your own everyday car into a sleek, sporty headturner. Working on a Daihatsu Cuore, this episode they are racing against the clock with only 8 hours and limited funds.

Take a look at how Nutz are mounted on a car - the ultimate bling for your vehicle.

Land Rover Magazine journalist, Mark Saville, gets some expert off-road driving instruction from Ed Cobley about how to tackle various muddy conditions.

Watch as John Edwards at Costa Mesa R&D uses a simple technique to seal leaking spark plug tubes on a Toyota cylinder head.

In this AeroCast episode, Anthony Bottini discusses the Power Off Stall maneuver as performed in the Piper Warrior (PA-28-161), referencing the procedures and standards outlined in the UND Aerospace Warrior Standardization Manual. All performance tolerances are based on the performance standards set forth by the FAA Private Pilot Practical Test Standards. Power Off Stall practice is vital in increasing a pilot's proficiency in regards to stall recognition and stall recovery techniques during an...

See how to install, rivet and tension a new chain on a Ducati Monster S2R. This video applies to all 2 Valve Ducatis.

Learn how to adjust the valves of your Ducati. This video applies to all 2 Valve Ducatis.

Watch and learn how to change the oil on your 2 Valve Monster, Supersport, Multistrada, Sport Classic, or ST Ducati motorcycle. This video is great if you want to learn how to save time and money by doing the work yourself.

Watch and learn how to correctly care for and maintain your motorcycle chain. Avoid chain "fling" and keep your chain in perfect condition for thousands more miles! This video applies to all Ducati Motorcycles.

Just because you don't drive a BMW that comes with these cool headlights stock, doesn't mean you can't have them. This video shows you how to wire angel eye (halo) headlights in a 99-04 Mustang.

This video shows you how to replace headlight bulbs and assemblies on a 99 - 04 Ford Mustang.

This video shows how to repair the damaged trailing edge of a wooden aircraft propeller using a scarf joint. It also shows how to fiberglass the repair.

Learn how to track a wooden aircraft propeller. This is a detailed, step-by-step explanation including how to torque your prop and properly place solid blocks as support.

This video will show you two different methods of repairing the leading edge of a wooden aircraft propeller. Learn how to properly apply epoxy, clean the area of the repair, and make the edge look like it was never damaged!

Learn how to refinish a wooden propeller for an airplane and repair small nicks using epoxy. Watch how to sand to prepare for the epoxy. (Afraid the epoxy will flow off? Learn how to keep it in place!) Be careful not to sneeze . . .

Sometimes less is more. If you want to clean up the front end of your Mustang try installing this grill delete kit from Classic Design Concepts.

A wider wheelbase will improve handling and make your vehicle look more aggressive. Here they show you one option to fill out those wheel wells: wheel spacers. Check out the before and after shots. Such a small change makes a huge difference!

Do you like to spoil your car with the highest quality oil but hate paying $80 every oil change? If you have the time and patience to follow this video you can have the best for your car at a fraction of the cost. Changing oil is not as hard as you may think - this video shows you how on a Ford Mustang.

Many repairs and modifications require you to work under your car. If you are fortunate enough to have a lift skip this video! For the rest of us, we need to make sure we raise our cars safely—this video gives an overview of steps applicable to most cars.

This video shows how to check your shock absorbers also known as dampers, shocks, shockers or shox. If they are no longer doing their job, they will need to be replaced.

This is a short video to ensure that you fit your wiper blades for a squeak and smear free swipe to provide perfect vision. The TP Performance blades won the auto express award of excellence.

Learn how to replace the factor airbox with a cone filter intake - this should flow more air through your engine to add a bit of horsepower and better performance.

This video shows you how to remove minor scratches from a Cobalt. It's almost impossible to completely remove all damage without repainting, but you can get pretty close - so check it out and learn how to get out those ugly scratches and nicks.

Need to clean out your brake booster lines? Sea Foam is the product to do it with and this video shows you how.

Watch and learn how to correctly change your timing belts. This video applies to all 2 Valve Ducati Engines (Monster, Monster S2R, Supersport, Multistrada, ST2, ST3, MH900e, Sport Classic)

Your vehicle's power steering pump is integral to your car functioning at all. That's because the power steering pump is what provides the hydraulic power for steering. Without it, your car would pretty much go nowhere. Inside the pump, retractable vanes spin, pulling hydraulic fluid in with low pressure and spitting it out at high pressure. Every pump has a pressure relief valve to make sure the pressure is never too high, but still your steering pump may wear out over time.

Car won't start? Watch this video to make sure you jump start your car properly.